Clicky

HomeExercise LibraryHow To: Bent Over Row

How To: Bent Over Row

Bent Over Row
The bent over row forms the basis of any good back workout, with the sheer amount of weight able to be lifted on the bent over row making it a fantastic choice for stacking on lean muscle mass and developing a strong, functional core.

This row works every portion of the back (from your trapezius to your erector spine).

When performing the barbell row I keep my body as parallel to the floor as possible, this allows full engagement of the rhomboids, which isn’t achieved when you’re in a more upright position (you’ll find most guys do these basically upright but with a very slight bend in their knees).

Movement: Compound

Targets: Back & Biceps

Required: Barbell

Optional: N/A

Bent Over Row Form:

Grip a barbell with an overhand grip before bending your knees, throwing your hips back and bringing your torso to a parallel position.

While keeping your core tight proceed to drive the barbell upward to just below your chest by contracting your shoulder blades together and keeping your shoulders as close in to your body as possible.

Slowly lower the barbell down until your arms are fully extended once again while your back remains as parallel to the ground as possible.

See also
Chin Ups For Biceps - The Often Neglected Arm Exercise For Bulging Biceps

Bent Over Row Variations

Underhand Grip Bent Over Row

By switching up your grip and utilizing a supinated (palms facing you) grip you'll place additional emphasis on the biceps.

Pendlay Row

The pendlay row is very similiar to the bent over barbell row however, the pendlay row 'resets' the bar after each repetition - lowering it back down to the ground momentarily.
The purpose of this 'reset' after each rep is to reduce the stress on the lower back.

Here's The Barbell I Use & Recommend...

I've been using one of these 'The Beast" 7 foot olympic barbells in my home garage gym for the last 6 years, it's affordable, high quality and gets the job done regardless of how many 45lb plates are loaded on it.
Check it out and invest in a high quality "The Beast" barbell here.

Common Bent Over Row Mistakes

Using Partial Range Of Motion

Each repetition should begin with your arms fully extended below your torso and end with the barbell up against your torso with your shoulder blades squeezed together.
Most guys continue to up and up the weight as their range of motion and form begins to degrade... don't be one of them.

Jerking Your Body To Complete The Repetition

The duration of the repetition should be slow and controlled, the top (contraction) portion of the repetition is by far the hardest, and if you're jerking your entire body to get the contraction this is a clear sign it's time to drop the weight down a bit.

See also
How To: Lat Pulldown

Not Bending Over Far Enough

It's called a bent over row for a reason, you must bent forward and row into your torso, standing straight up and attempting to row will not engage the desired muscle.

Not Squeezing The Shoulder Blades Together

Every back exercise comes down to getting the correct contraction - the contraction is a result of squeezing your shoulder blades together and tensing your back muscles as you've pulled the weight towards your torso. You cannot get this contraction without squeezing the shoulder blades.

I feel as if I repeat this point far too often, however for years I was merely training my back without contracting the muscles correctly... needless to say for a few years my back lagged behind the rest of my physique in terms of both size and strength.

Similar & Substitute Exercises 

  • One Arm Dumbbell Row
  • Seated Cable Row
  • Shotgun Cable Row

Any Questions Regarding The Bent Over Row? Ask Below!

Scott J.
Scott J.https://ignorelimits.com
I’m SJ. I’m a fitness enthusiast and published author. I transformed my body from a skinny fat 135lbs with 18% body fat to a solid 192lbs at 8% body fat. I became qualified in a field I was passionate about. I founded several online businesses that allow me to pursue ideas and projects in my life that I am passionate about without having to constantly worry about money. I published several eBooks explaining the training and dieting techniques I used to achieve the body I have today. I learnt a plethora of new information on dieting and fitness by reading and applying what I read, to find out what does work and what doesn’t work, because as I’m sure you’ve noticed the health and fitness industry is full of non-sense claims and BS. I found out what was true and what worked for me and applied that knowledge. And you bet I had fun during the whole process.

Stay in Touch

To follow the best weight loss journeys, success stories and inspirational interviews with the industry's top coaches and specialists. Start changing your life today!

Related Articles